Chapter 3 Installing and Removing Air Circulation Components

How to Install or Remove Air Circulation Components

Caution A fan tray weighs approximately 19.15 pounds (8.69 kg). Use both hands when handling a fan tray.

Step 6 Slide the fan tray into the bay.

Step 7 Slide the fan tray into the fan tray bay. Stop when the fan tray meets the chassis connector in the back of the fan tray bay.

Notice that the tray (and rail guides) drop just inside the fan tray bay door, so that the fan tray “drops” into its final position as it gets almost all the way into the chassis.

Caution To prevent damage to the chassis connector, do not use excessive force when inserting a fan tray into its bay.

Step 8 Firmly push on the fan tray to seat the fan tray connector in the chassis connector.

Note All electrical and control line connections are made automatically when the connectors mate.

Step 9 Rotate the fan tray handle to the closed (flush) position.

Step 10 Replace the fan tray bay door and tighten the two captive screws on the fan tray bay door.

What to Do Next

After performing this task, replace the front cover plates.

Removing an Upper Fan Tray

This section describes how to remove a fan tray from the upper fan tray slot of the Cisco CRS 8-slot line card chassis. For information on the chassis airflow and circulation, see the “About Line Card Chassis Airflow” section on page 3-1. For complete information on regulatory compliance and safety, see Regulatory Compliance and Safety Information for the Cisco CRS Carrier Routing System.

A Cisco CRS 8-slot line card chassis fan tray operates in either the upper or lower fan tray slot. Each fan tray is installed into the rear (MSC) side of the chassis (see Figure 3-4).

Prerequisites

Before performing this task, you must first open the chassis doors and remove any front cosmetic covers.

Required Tools and Equipment

You need the following tools to perform this task:

ESD-preventive wrist strap

Large Phillips screwdriver

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

3-8

OL-6256-17

 

 

Page 94
Image 94
Cisco Systems OL-6256-17 manual Removing an Upper Fan Tray