assembly
INSTALLING AND TENSIONING BELT
1.Place a straightedge such as a piece of wood, metal or framing square across the pulleys.
2.Move the motor UPWARDS until the pulleys are IN LINE ... tighten the motor mounting nuts with a ½ in. wrench.
3. | Place the | belt | on the pulleys. |
| BELT TENSIONIN_ | V | ||||
|
|
|
|
|
|
|
| |||
4, | Put | a dab | of | grease | such | as Sears | gear case lubricant on | MOTOR | ||
f | ||||||||||
| the | rubber | tip of the | BELT | TENSIONING | ROD, | ||||
|
| |||||||||
5. Loosen HEX HEAD SCREW with a 7/16 in. wrench | MOTOR | |||||||||
MOUNT | ||||||||||
| ... | position | BELT | TENSIONING | ROD | as shown. | ||||
|
| |||||||||
6.Push the motor to the right with moderate pressure
while pushing THE BELT TENSIONING rod against
the motor mount ... TIGHTEN the HEX SCREW.
7_ If belt slips while drilling, readjust belt tension.
8.Replace the belt guard.
iNSTALLING LIGHT BULB
1.Install a light bulb (not larger than 60 watt) into the socket inside the head.
\
12
