9.Gently push down on the FEED HANDLES until the head raises upwards as far as it will go.
10, TIGHTEN THE HEAD LOCK HANDLE AND THE QUILL LOCK HANDLE.
11.HOLD onto the Feed Handle and UNLOCK the quill lock handle.
12, Let the quill return to the UP position in the head.
!3. TIGHTEN THE QUILL LOCK HANDLE.
Repeat steps 3 thru 10 until the head is raised to the
desired position, Position HEAD SUPPORT COLLAR underneath the head and tighten the bolts.
CAUTION: Do not raise the head above the top of the column.
HANDLE
HEAD LOCK
HANDLE
INSTALLING MOTOR PULLEY
When using a double shaft motor, remove the KEY from the 5/8 in, dia. shaft.
1. Using a 5/32 in, setscrew wrench, UNSCREW the setscrew in the pulley so that it is clear of the
KEYWAY (GROOVE).
2.Place the pulley on the shaft. Make sure it slips on
EASILY ,.. don't FORCE it, Remove any burrs in the pulley or on the shaft if any,
3.Position the pulley so that the KEYWAYS in the shaft and in the pulley line up; and the small end of the pulley is about !/16 of an inch away from the motor.
