Sears 113.21371 manual getting, know, your, drill, press

getting		to	know	your	drill	press
			-4.--	SPLINES		SWITCH
						KEY
			(GROOVES)
				SPINDLE
		QU ILL "_			DRILL
				RACK	"ON-OFF"
QUILL AND	SPINDLE	ASSEMBLY		(TEETH)	SWITCH
INSIDE	OF DRILL	PRESS
					DEPTH		SUPPORT
					QUIL		COLLAR
					HANDLE		"THUMB SCREV/
						DEPTH
						POINTER	rEED HANDLE
					CHUCK	LOC!	LOCK
		CHUCK	_,.__...		COLLAR		HANDLE

CHUCK

KEY

TABLE SUPPORT

COLLAR

HEAD LOCK HANDLE

ON LEFt SIDE OF HEAD

SPINDLE SPEED CHART

BELT TENSION ROD.,, maintains constant tension on the

belt, TO RELEASE belt tension for changing speeds, push the GRIP of the rod up.

To APPLY belt tension, PUSH the MOTOR to the REAR while pulling DOWN on the GRIP of the rod. Belt should only be tight enough so that it does not slip. If belt slips

while drilling, readjust belt tensioning rod

FEED HANDLES ... are for moving the quill up or down. One or two may be removed if necessary whenever the

workpiece is of such unusual shape that it interferes with the handles.

Although there is a rubber cushion between the FEED

STOP COLLAR and the head, NEVER let go of the feed handles when you have finished drilling a hole.

Hold on to the handle while allowing the quill to return to the UP position.

DRILLING SPEED ...Canbechanged by placing the belt in any of the STEPS (grooves) in the pulleys. See Spindle Speed chart on right side of Head.

To determine the approximate drilling speed, refer to the

table on the RIGHT side of the drill press head, For example to drill a 5/8 inch hole in wood, the belt is placed in the FOURTH step from the top. The speed will then be 2300 RPM (revoJutions per minute).

QUILL LOCK ... Holds the quill at any desired point within its travel.

To lock the quill requires only moderate pressure on the lock handle.

FEED STOP NUT limits the downward movement of the

quill at any desired point within its travel, and prever_ts the pointer from moving upward,

The DEPTH PONTER is !ocked M piace with _he

THUMBSCREW.

_3