Sears 113.21371 manual Assembty, Mounting the Motor

assembty

NOTE: When using motors which have Y2" dia. shafts, place the adapter sleeve (furnished with the motor) on the shaft so that the slot in the sleeve is over the flat spot.

4.Insert the shaft key (furnished with motor) into the grooves in the shaft and pulley so that the end of the key is even with the end of the shaft,

5.Tighten the set screw. Use a pair of pliers on the short end of the set screw wrench for increased leverage.

MOUNTING THE MOTOR

1, Position the motor mount as shown and place the motor on top of it.

2, Find four 5/16 in.--18 x 1 in. CARRIAGE BOLTS, flat wash_;rs and hex. nuts, among the loose parts.

3, Insert the bolts as shown ,.. install washers . .. screw

on nuts but DON'T TIGHTEN them:

"_/}6 y 3/16 KEY

FLAT SPOT

		I
1/2	IN. DIA.	EEVE
MOTOR	SHAFT

RRIAGE BOLT

4.Using a 5/32 inch set screw wrench unscrew the PIVOT screws as shown,

_ SCREW

10