assembly
INSTALLING THE DEPTH STOP
1.Screw the THUMB SCREW partways into the DEPTH POINTER.
2.Place the DEPTH POINTER SHOE inside the pointer.
3.Loosen QUILL LOCK HANDLE ... lower the quill about two inches.
4.Slide the pointer and shoe onto the FEED STOP ROD and tighten the thumb screw. Make sure the pointer is positioned as shown,
5.Screw the FEED STOP NUT onto the top of the feed stop rod.
6.Move the pointer upwards against the nut and tighten the thumb screw.
7.Tighten QUILL LOCK HANDLE.
DEPTH | FEED f |
POINTERSTOP
DEPTH STOP
SHOE
RAISING THE HEAD
1.Loosen the TABLE LOCK HANDLE.
2.Place a piece of WOOD on the table. USE TH E packing block.
3.Turn the CHUCK SLEEVE until the jaws are all the way up inside the chuck.
4.Raise the table until the wood block touches the chuck body.
5.Tighten the Table Lock Handle.
6.Locate the two clamps and bolts that you removed from the paper tube when you first started unpacking your drill press.
These parts make up the TABLE SUPPORT COLLAR. Position the TABLE SUPPORT COLLAR underneath
the table and tighten the bolts,
7.Loosen the HEAD LOCK HANDLE.
8, Loosen the QUILL LOCK HANDLE.
QUILL LOCK
HANDLE
HEAD LOCK
HANDLE
(RIGHT HAND SIDE)
PIECE OF WOOD
TAE
COLLAR
