– 13–

Surround Speaker

If your speaker is going to be used
as a surround speaker, refer to the
diagram below.
1. Set the input jumper (located on
the back of the speaker) to Single
Input Setting (see 1).
2. Connect the speaker wire to Input
“A”only. Check that you have
retained proper polarity (see 2).
3. The speaker can be configured for
either direct or diffuse mode (VSi
H470T2) when used in this appli-
cation (see 3). It is recommended
that you experiment with both
settings to determine which set-
ting works better for your applica-
tion.

Altavoz ambiental

Si va a usar el T2 como altavoz
ambiental, consulte el croquis
siguiente.
1. Coloque el puente de entrada
(situado en la parte trasera del
altavoz VSi H470T2) en la opción
de entrada única (ver 1).
2. Conecte el cable del altavoz sólo
a la entrada “A”. Compruebe que
ha conservado la polaridad cor-
recta (ver 2).
3. El altavoz T2 puede configurarse
tanto en modo directo como
difuso cuando se use en esta
aplicación (ver 3). Es aconsejable
que experimente con ambas
configuraciones para determinar
cuál de ellas funciona mejor para
la aplicación.

Enceinte Surround

Si vous allez utiliser votre enceinte
T2 comme enceinte Surround,
reportez-vous au diagramme ci-
dessous.
1. Placez le cavalier d’entrée (situé à
l’arrière de l’enceinte VSi H470T2)
à la position « Single Input » (voir
1).
2. Connectez les câbles d’enceinte à
« Input A » uniquement. Assurez-
vous de maintenir la polarité cor-
recte (voir 2).
3. Sous cette application, l’enceinte
T2 peut être configurée pour les
modes direct ou diffusion (voir
3). Nous vous recommandons
d’essayer les deux configurations
pour déterminer quel réglage
convient le mieux à vôtre appli-
cation.

Surround-Speaker

Soll Ihr T2-Speaker als Surround-
Speaker dienen, beziehen Sie sich
auf die Abbildung hier unten.
1. Die Eingangs-Steckbrücke (hin-
ten am VSi H470T2-Speaker) auf
Single Input Setting (einzelner
Eingang) (siehe 1) stellen.
2. Das Lautsprecherkabel nur an
den Eingang „A“ anschließen.
Kontrollieren, dass die richtige
Polarität eingehalten wird (siehe
2).
3. Der T2-Speaker kann in dieser
Betriebsart entweder im direkten
oder im diffusen Modus einge-
setzt werden (siehe 3). Es wird
empfohlen, beide Einstellungen
auszuprobieren, um die für Ihre
Anwendung ideale Einstellung zu
finden.
Diagram #3
3
2
1