NEC ND-91649 manual Modules and Installation Hardware, System Configuration

SYSTEM CONFIGURATION

Modules and Installation Hardware

The NEAX 2000 IPS is comprised of up to 8 Port Interface Modules (PIMs).

Modules

(1)Port Interface Module (PIM)

A PIM provides 13 card slots for common control, Line/Trunk (LT), and Application Processor (AP) cards. It also houses an AC/DC Power Supply (or DC/DC Power Supply), optional DC/DC Power Supply (for -48V), and batteries for protection from short-term (about 30 min.) power interruption.

Four champ connectors for Line/Trunk (LTC 0 to 3) are located at the lower front side of the PIM.

A PIM provides a maximum of 12 card slots for Line/Trunk (LT) and Application Processor (AP) cards. At maximum configuration, the system is comprised of 8 PIMs.

PIM MD	PIM MD
(PIM3)	(PIM7)
PIM MD	PIM MD
(PIM2)	(PIM6)
PIM MD	PIM MD
(PIM1)	(PIM5)
PIM MD	PIM MD
(PIM0)	(PIM4)

Single MP System

PIM MD	PIM MD
(PIM3)	(PIM7)
PIM MD	PIM MD
(PIM2)	(PIM6)
PIM MD	PIM MD
(PIM1)	(PIM5)
PIM MF	PIM MD
(PIM0)	(PIM4)

Dual MP System

(2)Battery Module (BATTM)*

The BATTM is an optional module for installing optional long-term (about 3 hours) backup batteries. The BATTM is designed to accommodate batteries covering up to a 4-PIM system (2 BATTMs support maximum system configuration).

The BATTM is available for Floor Standing Installation. (When the system is Wall-mounting/19-inch Rack-mounting configuration, the BATTM cannot be installed with the PIM.)

Table 2-1 Modules of NEAX 2000 IPS System

Abbrev	Name Code	Remarks
PIMMD	SN1617 PIMMD	PIM 0 ~ PIM 7
PIM MF	SN1658 PIMMF	PIM0 for dual MP system
BATTM	SN1619 BATTMB	1/STACK, Max.2/system

* Battery Module is available for Latin America.
CHAPTER 2	ND-91649(E)
Page 14