NEC ND-91649 manual Specifications, 1 System Capacity Single MP System Cont’d

						SPECIFICATIONS
Table 5-1 System Capacity (Single MP System) (Cont’d)
Item				System Capacity
		1PIM	2PIM	3PIM	4PIM	5PIM	6PIM	7PIM	8PIM
Attendant Terminal (Dterm ATT Position)				Max. 8 sets per system
SMDR Interface				Max. 1 interface port per system
PMS Interface				Max. 1 interface port per system
ACD / MIS or OAI Interface	Note 8			Max. 1 interface port per system
Remote PIM over IP (Number of PIM at Remote Site)			20 (depending on network configurations)
DID Dial Conversion			1000
Call Forwarding-Outside Set			496
Authorization. Code / Forced Account Code / Remote Access			3000
to System (DISA) Code
Message Remainder Set			1024
Name Display / Guest Name Display			512
Speed Calling-Station (Station Speed Dial) Set			10000
MP built-in SMDR Call Record			1280

Note 1: The total number of trunk line and DTI channel shall be 256 or less.

(Each trunk line and DTI channel are required to assign the “Trunk Number” by system data programming and maximum number of system parameter for “Trunk Number” is 256.)

Note 2: “PIM” in this table means “Physical PIM.”

Note 3: Maximum number of voice channels per IP PAD card depends on the payload size as follows.

32IPLA+16VCTA

Payload Size	Maximum Voice Channels per IP PAD (32IPLA+16VCTA)
	G.711	G.729a	G.723.1
10ms	12	12	-
20ms	20	20	-
30ms	30	30	24
40ms	32	32	-
8IPLA+24IPLA
Payload Size	Maximum Voice Channels per IP PAD (8IPLA+24IPLA)
	G.711	G.729a	G.723.1
10ms	20	20	-
20ms	32	32	-
30ms	32	32	24
40ms	32	32	-

ND-91649(E)	CHAPTER 5
	Page 43