Speaker connections for stereo configurations | a/d/s/ PH30.2

Connect to 12V turn-on lead from source unit

70A

fuse

Connect to chassis of vehicle

Factory chassis ground

Connect to chassis of vehicle

70 Amp fuse

less than 18" from battery

speaker connections for stereo configurations

Minimum recommended impedance is 2 stereo. Speaker terminals accept up to AWG #12 speaker wire.

70A

speaker connections for bridged configurations

Minimum recommended impedance is 4 when bridged to subwoofers and 4 when bridged to full range speakers. Speaker terminals accept up to AWG #12 speaker wire.

70A

13

Image 14

a/d/s/ PH30.2 manual Speaker connections for stereo configurations, Speaker connections for bridged configurations

Contents

PH30.2 Table of contents Introduction Keep listening, but be safe Features of your PowerPlateAbout this manual Trunk compartment mounting Mounting locationsPassenger compartment mounting Engine compartment mounting System planning Speaker requirements System configurations 70A Left tweeter Right tweeter Left midrange Right midrange Subwoofer Right satellite Left satellite Subwoofer Page Amplifier and crossover controls Controls and connections InstallationPower connections Speaker connections for stereo configurations Speaker connections for bridged configurations Signal sources Pin Wire Color Internal signal routing Multi-cross crossover configuration Digital crossover frequency display Tuning the crossover Using the AC502 optionalTuning Constant Bass circuit Adjusting input sensitivity Audio cycles on and off TroubleshootingNo output Distorted output Poor bass response Battery fuse blowingDistorted output cont’d Amplifier fuse blowing Specifications Amplifier section Warranty information Limited TWO Year Consumer Warranty Directed Electronics, Inc. All rights reserved G49200