Manuals / Abocom / Computer Equipment / Network Router

Abocom AR1000 manual Powering On the ADSL ROUTER

Models: AR1000

1 8

Page 5

Step 4 Connect one end of RS-232 cable to any free COM port in your system; Connect the other end to “Console” port on the rear panel of the ADSL router.

Powering On the ADSL ROUTER

Step 1 Connect the power adapter to your ADSL ROUTER by plugging one end of the power supply into an appropriate electrical outlet and the other end into port labeled 5VDC on the rear panel of the device.

Note: To power off he ADSL ROUTER, just unplug the power supply cable from the ADSL ROUTER rear panel POWER connector.

Step 2 Once your ADSL ROUTER is powered up, check to make sure the Power LED is red and ON.

Step 3 If the Power LED is not lit, immediately turn off all power to the ADSL ROUTER.

- 4 -

Page 5

Image 5

Abocom AR1000 manual Powering On the ADSL ROUTER

Contents

M73-APO07-110 ADSL ROUTER Quick Installation GuideParts Names and functions LED IndicatorRear view of the ADSL ROUTER Top View of ADSL ROUTER LEDsConnectors on the rear panel Connectors on the Rear PanelConnecting All Cables to the Network Setting Up the Hardware EnvironmentHome Network - ADSL Router connection through Ethernet Switch/Hub One PC - ADSL Router direct connectionPowering On the ADSL ROUTER INTERNET ACCESS Router Mode/ IP over ATM RFC15773 Check “Router Protocol” and select “IP over ATM” Bridge mode/RFC1483 bridge 7 Check “LLC Encapsulation” or “VC Based Route” or “VC Based Bridge”