THINGS YOU OUGHT TO KNOW
WHEN YOUR FREEZER IS INSTALLED
INSPECT
Inspect for shipping damage. If damaged or parts are missing, notify your Absocold dealer at once.
INSTALLATION REQUIREMENTS
Remove all packing material and tape. Install on a level floor or
ELECTRICAL REQUIREMENTS
120 volts, 60 Hz.
ELECTRICAL GROUNDING
(for
Must be grounded. Uses
Unless the above grounding method is followed, you are not protected against severe or lethal shock, in the event of a short circuit of an electrical component or wiring of freezer.
CAUTION
Should you unplug freezer, allow at least three minutes before restarting in order to allow the start relay to function properly.
USE AND CARE INFORMATION
•TIPS ON EVERYDAY USE AND CARE
TEMPERATURE CONTROL:
The freezer temperature can be adjusted by the Cold Control Knob. Freezer temperature will become lower as the control knob is set closer to the MAX position. Freezer temperature will vary depending on the quantity of food stored and the frequency with which the door is opened. Ice cream can be used as an indicator of freezer temperature. If it is too hard or too soft, adjust the Cold Control Knob accordingly.
HOW TO DEFROST:
Remove contents from freezer. Keep drip tray in place. Set Cold Control knob to OFF position.
Defrosting may take up to several hours. To defrost faster: |
| |
* Leave door open | * Place pans of hot water on frosted shelves. | * Wipe with warm towel or sponge |
NEVER USE A KNIFE OR METAL OBJECT TO REMOVE FROST OR ICE, AS THIS MAY SEVERELY DAMAGE THE REFRIGERATION SYSTEM.
When defrosting is complete, remove drip tray and dispose of water. Set Cold Control back to original position.
FOR ALL CLEANING: Mix 2 tablespoons baking soda or 2 tablespoons of mild soap with 1 quart warm water. No strong cleaners, scouring powder or pads should be used. Do not put the defrost tray in dishwasher.
•THINGS TO REMEMBER:
1.Allow 24 hours for your freezer to reach a new temperature setting.
2.The motor will start and stop often. It must do so in order to maintain the temperature you select.
3.Keep your freezer reasonably level.
4.Unplug freezer before doing anything with the electrical system.
•BEFORE CALLING FOR SERVICE
Read all Use & Care Information, as your questions may be answered. If not, find your model number (on upper back of freezer). Refer your model number and serial number to Absocold Corporation at (800)
FREEZER IS TOO WARM: Adjust Cold Control. Make sure door is closed properly.
MOISTURE COLLECTS ON THE OUTSIDE: Frequent door opening in highly humid conditions will cause this. Reduce door openings and reduce time door is open. Make sure door seal is tight.
FREEZER IS NOISY: Make sure cabinet is level, and not touching a wall or other surface. Make sure condenser coils are free of lint and dust. Normal noises include refrigerant gurgling as it passes through tubes and the compressor clicking on and off.
ENERGY SAVING TIPS - WAYS TO SAVE POWER, SAVE MONEY, AND STILL ENJOY YOUR FREEZER
•Reduce door openings.
•Close the door as soon as you can.
•Adjust temperature control to warmer setting when practical.
•Don’t allow more than 1/4” of frost to build up on evaporator coils.
•Keep your freezer away from stoves or other heat sources.
WARNING!
•Your freezer should be connected directly to a grounded electrical wall outlet. No extension cords,
•In case of prolonged power outage or an electrical disconnect of any type, please check your freezer for spoiled food.