Quick Installation Guide
Troubleshooting
Check the following troubleshooting items before contacting Accton Technical Support.
PCI Compatibility
Some PCI computers are not
•Make sure your BIOS correctly supports the PCI Local Bus Specification v2.0 or later and upgrade your computer BIOS to the latest version.
•Verify that the PCI slot is an enabled
•In some computers, you may be required to disable Plug ‘n Play (PnP) in the BIOS Setup program if resources are not properly assigned between installed cards.
•Some computers may require you to reserve interrupts and memory addresses for installed ISA cards to prevent PCI cards from using the same settings. Refer to your PC’s manual and check the PCI BIOS Setup program configuration options for ISA cards.
•Make sure the PCI slot is configured to support INTA.
•Be sure that INTA for the slot is assigned to a free interrupt (IRQ) number.
•Check the BIOS Setup program’s PCI parameters for the slot where the Cheetah PCI Adapter is installed. Be sure the slot is configured for
PCI Slot #: | (slot number where the network card is installed) |
Master: | Enabled |
Slave: | Enabled |
Latency Timer: | 40 (range is 20 to 255) |
Interrupt Type: | |
Interrupt Number: | (choose any number the BIOS Setup supplies |
| that does not conflict with another installed card) |
Note: The wording of these parameters varies with different computers, and not all parameters may be configurable.
Always consult your computer manual for information on changing motherboard jumper settings and BIOS Setup program parameters for use with PCI network cards. If you set a motherboard jumper and modify the computer’s BIOS Setup, make sure the jumper and BIOS settings match.
6
