VG3300 series user guide

9.1.2. System console settings (Only VG3306/3310/3318)

SIP-RG>enable SIP-RG #configure

Enter configuration commands, one per line. End with CNTL/Z SIP-RG(config)#regional_id 07

SIP-RG(config)#exit SIP-RG#delete nvram

This command resets the system with factory defaults.

All system parameters will revert to their default factory settings. All static and dynamic addresses will be removed.

Reset system with factory defaults, [Y]es or [N]o? Yes

Attention:

Before Changing the Region ID, the system has to be reset to the default value. Therefore this step should be done first.

The following instruction may keep the IP address unchanged after reset: “delete nvram keep_ip”

9.2.IP Address Settings

We recommend using a traditional phone to configure the unit’s parameters, as this is the easiest way. The following two sections contain the procedures used to configure the gateway according to how you obtain your IP address (Static IP; DHCP or PPPoE).

Every time you set a parameter item and press the “#” key to complete it, a successful setting will be confirmed by three equal tones in succession. If your setting is unsuccessful you will be prompted with one long tone.

13