VG3300 series user guide

2.Connect a traditional phone set to the “FXS” connector located on the rear panel.

3.When the CPU/ACT light is on, pick up the phone to hear the dialing tone.

4.

##0000

; you should hear three short tones.

5.

011#

; the digit “0” is used to enable “manual” IP mode.

6.

15123#

; “123” is the web management password.

7.

981#

; Warm-restarts.

8.

Hang up the phone. The system should now restart.

You can also use console to configure IP address. SIP-RG>enable

SIP-RG#configure

Enter configuration commands, one per line. End with CNTL/Z SIP-RG(config)#ip state dhcp

SIP-RG(config)#exit SIP-RG#restart

This command resets the system. System will restart operation code agent. Reset system, [Y]es or [N]o? Yes

9.2.3. PPPoE Mode

If your network environment is using PPPoE, you need to prepare the information as specified in section 8. Information required before Installation.

The following table shows an example.

PPPoE Account

83721@hinet.net

 

 

PPPoE Password

123ab

 

 

Web management password

123

 

 

There are three ways to configure user name and password of PPPoE

1. Use phone set to configure:

You can configure the user name and password by using phone set. The command ‘09’ is used for username and ‘10’ is for password of PPPoE. Since the user name and password use characters and digits are accepted by phoneset only, you need a mapping between characters and digits. You can find them at section 15.4

15