Mapping table of characters used in PPPoE.

Example user name：83721@hinet.net，Password：123ab，The procedure is below

1.Connect the phone to the gateway

2.When CPU/ACT is light, pick up the phone and press

3.

##0000

；You will hear 3 short tones.

4.

0938333732314068696*465742*46*46574#

；Set user name：83721@hinet.net

5.

103132336162#

；Set password is 123ab

6.

981#

；Save and restart.

2. Use Console to configure (Only VG3306/3310/3318)

SIP-RG>enable SIP-RG#configure

Enter configuration commands, one per line. End with CNTL/Z SIP-RG(config)#pppoe username 83721@hinet.net SIP-RG(config)#pppoe password 123ab SIP-RG(config)#exit

SIP-RG#restart

This command resets the system. System will restart operation code agent. Reset system, [Y]es or [N]o? Yes

3. Use WEB Interface to configure:

You can configure the user name and password by using WEB interface. Follow the steps to finish configuration.

Step 1: Using a traditional phone set to configure the web management password and phone number

You will need to use a web browser to perform the PPPoE settings through the gateway’s web based management interface. To enter the web based management interface you must have a previously configured password. Follow the next procedure to setup your password and phone number.

1.Connect the gateway to a suitable Power source.

2.Connect a traditional phone set to the “Phone” connector located on the rear panel.

3.When the CPU/ACT light is on, pick up the phone. You should hear the dialing tone.

4.

##0000

; you should hear three short tones.

5.

15123

; “123” is the web management password.

 

 

 

 

 

16