9.2.1. Static IP Mode

The following table shows an example.

IP Address

210.67.96.121

 

 

Subnet Mask

255.255.255.248

 

 

Default Gateway

210.67.96.120

 

 

Web Management

123

Password

 

 

 

Using the information contained in the example above. The procedure is as follows:

1.Connect the gateway to a suitable Power source.

2.Connect a traditional phone set to the “FXS” connector located on the rear panel.

3.When the CPU/ACT light is on, pick up the phone to hear the dialing tone.

4.

##0000

; you should hear three short tones.

5.

010#

; the digit “0” is used to enable “manual” IP mode.

6.

02210*67*96*121#

 

; IP address.

7.

03255*255*255*248#

; Subnet Mask.

8.

04210*67*96*120#

 

; Default Gateway.

9.

15123#

 

; “123” is the web management password.

10.

981#

; Warm-restarts.

11. Hang up the phone. The system should now restart.

You can also use console to configure IP address. But phone number can’t be configured by console.(Only VG3306/3310/3318)

SIP-RG>enable SIP-RG#configure

Enter configuration commands, one per line. End with CNTL/Z SIP-RG(config)#ip state user

SIP-RG(config)#ip address 210.67.96.121 255.255.255.248 System need to restart

SIP-RG(config)#ip default-gateway 210.67.96.120 SIP-RG(config)#exit

SIP-RG#restart

This command resets the system. System will restart operation code agent. Reset system, [Y]es or [N]o? Yes

9.2.2. DHCP Mode

1.Connect the gateway to a suitable Power source.

14