,QVWDOOLQJDQ8SJUDGH0LFURSURFHVVRULQ 3RZHU(GJH6\VWHPV
This section provides instructions for:
‡
‡
‡
Removing the cooling shroud,
Installing the new SEC cartridge and heat sink and replacing the cooling shroud
Reassembling and checking the system
5HPRYLQJWKH&RROLQJ6KURXG6(&&DUWULGJHDQG +HDW 6LQN
127,&()ROORZWKHLQVWUXFWLRQVLQ´3UHFDXWLRQDU\0HDVXUHVµWRHQVXUHWKDW WKHV\VWHPLVSURSHUO\VKXWGRZQDQGGLVFRQQHFWHGIURPDOOSRZHUVRXUFHV
(QVXUHWKDWWKHV\VWHPFRQILJXUDWLRQVFUHHQVDUHUHFRUGHGDVGHVFULEHGLQ ´%HIRUH<RX%HJLQµ
1.Turn off the system, including any attached peripherals, and disconnect the power cable from the electrical outlet.
2.Remove the
See your system Installation and Troubleshooting Guide for specific instructions, if needed.
3.Remove the cooling shroud as follows:
a.Unscrew and remove the two retention pins (see Figure
b.Remove the shroud by lifting the end of the shroud closest to the micropro- cessor(s) until the opposite end of the shroud disengages from the cooling fan on the system’s back panel (see Figure