Setup Utility
Chapter 5 Software 87
Parallel Port Enables or disables the parallel port.
Options: Enabled or Disabled
Operation
mode Sets the operation mode of the parallel port.
Options: Output only, Bi-directional, or ECP
Base I/O
Address Sets the I/O address of the parallel port.
Options: 378, 278, or 3BC
Interrupt Sets the interrupt request of the parallel port.
Options: IRQ 7 or IRQ 5
ECP DMA Assigns DMA channel 1 or DMA channel 3 for
ECP parallel port function.
This item becomes active only if you select
Extended Capabilities Port (ECP) as the
operation mode.
Options: DMA 1 or DMA 3
Speaker Enables or disables the internal speakers. You
can override this by toggling Fn-F6 during
computer operation.
Options: Enabled or Disabled
Boot Display
Device Sets the display on boot-up.
When set to Auto, the computer automatically
determines the display device. If an external
display device (e.g., monitor) is connected, it
becomes the boot display; otherwise, the
computer LCD is the boot display. When set to
Both, the computer outputs to both the
computer LCD and an external display device if
one is connected.
Options: Auto or Both
Parameter Description
310-e.book Page 87 Tuesday, October 27, 1998 5:17 PM