3 System upgrade
48
(3) Attach the system’s power cable to the SATA power cable
connector on the backplane (4).
(4) Attach the SATA backplane SAF-TE cable to the JP3 connector
on the backplane (5), then connect the other end of the cable
to the I2C connector on the RAID controller.
Refer to the illustration below when installing the SATA
backplane, or removing and replacing the cables.
Note: The SATA RAID backplane data cables must be installed and
removed in the following order: SATA0, SATA1, SATA2, and
SATA 3.
5 Observe the post-installation instructions described on page 40.
Important: When you are detaching the hot-plug cage from the
chassis, make sure to first remove all hard disks from their carriers.
For instructions, refer to the succeeding section.