Electrical Requirements, Standard Test Conditions

Electrical Requirements

All tests shall be performed under the following conditions, unless otherwise specified.

Ambient light	Dark room (< 1 cd/m2)

Viewing distance	40 cm for LCD performance, 20 cm for LCD failures
Warm up time	＞30 minutes

Analog Input signal	700 mVss
Control temperature	6500°K (e-Color set to “User” mode)

Brightness control	The value under user mode
	Set to The value under user mode, which allows that the brightest
User contrast control	two of 32 linear distributed gray-scales (0～ 700mv) can be
	distinguished.
Picture position and size	Factory preset value

Viewing angle	90 ° H and V
AC Supply voltage	230V± 5％, 50±3Hz
Ambient temperature	20+5℃
Humidity	65% ± 20%
Display mode	1680x1050, 60 Hz, all white

e-color mode	Set to “User” mode

The units of measure stated in this document are listed below: 1 gamma = 1 nano tesla

1 tesla = 10,000 gauss cm = in x 2.54

Lb = kg x 2.2

Degrees F = [°C x 1.8] + 32 Degrees C = [°F - 32]/1.8 u' = 4x/(-2x + 12y + 3)

v' = 9y/(-2x + 12y + 3)

x = (27u'/4)/[(9u'/2) - 12v' + 9] y = (3v')/[(9u'/2) - 12v' + 9] nits = cd/(m2) = Ft-L x 3.426 lux = foot-candle x 10.76