Acer P1265, P5270 manual Problems with the Projector, English

English

26

9	Image is too small	•	Adjust the zoom lever on the top of the projector.
	or too large	•	Move the projector closer to or further from the
			screen.
		•	Press "MENU" on the remote control or on the
			control panel. Go to "Image setting --> Aspect
			Ratio" and try different settings.
10	Image has slanted	•	If possible, reposition the projector so that it is
	sides		centered on the screen.
		•	Press the "Keystone / " button on the control
			panel or press the "Keystone / / / " on the
			remote control until the sides are vertical.
11	Image is reversed	•	Select "Image --> Projection" on the OSD and adjust
			the projection direction.
Problems with the Projector
#	Condition			Solution
1	The projector stops responding			If possible, turn off the projector, then
	to all controls			unplug the power cord and wait at least 30
				seconds before reconnecting power.
2	Lamp burns out or makes a			When the lamp reaches the end of its useful
	popping sound			life, it will burn out and may make a loud
				popping sound. If this happens, the projector
				will not turn on until the lamp module has
				been replaced. To replace the lamp, follow
				the procedures in the "Replacing the Lamp"
				section.