|
|
|
|
|
| 19 |
|
|
|
|
|
| |
|
|
|
|
| ||
|
|
|
| • | When you select this function, the projector reverses and inverts | |
|
|
|
|
| the image at same time. You can project from behind a | |
|
|
|
|
| translucent screen with ceiling mounted projection. | |
|
|
|
|
|
|
|
H. Position | • | Press | to move the image left. | |||
(Horizontal | • |
|
| |||
position) | Press | to to move the image right. | ||||
|
|
|
|
|
|
|
V. Position | • | Press | to move the image down. | |||
(Vertical position) | ||||||
|
|
|
| • | Press | to move the image up. |
|
|
|
|
| ||
Frequency | "Frequency" changes the projector's refresh rate to match the | |||||
|
|
|
| frequency of your computer’s graphics card. If you can see a vertical | ||
|
|
|
| flickering bar in the projected image, use this function to make the | ||
|
|
|
| necessary adjustments. | ||
|
|
|
|
| ||
Tracking | Synchronizes the signal timing of the projector with the graphics card. | |||||
|
|
|
| If you experience an unstable or flickering image, use this function to | ||
|
|
|
| correct it. |
| |
|
|
|
|
| ||
Sharpeness | Adjusts the sharpness of the image. | |||||
|
|
|
| • | Press | to decrease the sharpness. |
|
|
|
| • | Press | to increase the sharpness. |
|
|
|
|
| ||
Signal Type | Select signal type from RGB, YCbCr or YPbPr source. | |||||
|
|
|
|
|
|
|
Note: "H. Position", "V. Position", "Frequency" and "Tracking" functions are only supported under Computer mode.
Note: "Sharpness" and "Signal Type" functions are only supported under Video mode.
