Samsung HLN507W, HLN567W Front Panel LED Indicators, Rear Panel Jacks, Indicator Light Key

BP68-00142A-1 5/27/03 10:09 AM Page 14

Your New Wide TV

Front Panel LED Indicators

The three lights on the front panel indicate the status of your TV.

Indicator Light Key

: Light is On

: Light is Blinking

Rear Panel Jacks

Use the rear panel jacks to connect components such as a VCR.

You can connect two different components such as two VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks and one set of component video input jacks on the rear panel of your TV. For more information, please see “Connections”.

: Light is Off

Timer Lamp Temp Indication

Auto Timer ON/OFF has been set

Standby state.

The picture will automatically appear in about 25 seconds.

Auto Timer ON/OFF has been set and the set will automatically be turned on in about 25 seconds.

A cooling fan inside the set is not operating normally.

Lamp cover on rear of the set is not properly shut.

Check if the ventilation hole on the rear of the set is blocked, because if the inner temperature is too high, the power will shut off.

Lamp may be defective. Please contact a certified technician.

•It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.

•The TV has a fan to keep the inside lamp from overheating. You’ll occasionally hear it working.

ŒANTENNA terminals

Two independent cables or antennas can be connected to these termi- nals. Use ANT-A and ANT-B terminals to receive a signal from VHF/UHF antennas or your cable system. Use the ANT A-OUT termi- nal to send the signal being received by the ANT-A terminal out to another component (such as a Cable Set Top Box).

The PIP channel can be received only when a signal source is connected to ANT-A.

´S-VIDEO INPUT jacks

Connects an S-Video signal from an S-VHS VCR or DVD player.

ˇVIDEO/AUDIO INPUT jacks(VCR1, VCR2)

Connect video/audio signals from external sources, such as a VCR or DVD players.

¨VIDEO/AUDIO MONITOR OUTPUT jacks

Sends a video signal from the TV to an external source, such as a VCR.

Note: Monitor Out is available only in RF, Video and S-Video modes.

ˆComponent1 jacks (Y, Pb, Pr, L, R)

Use these jacks to connect the component video/audio signals from a DVD player when using the component video input jacks.

Note: Only 480i and 408p formats are supported.

ØComponent 2, 3 jacks (Y, Pb, Pr, L, R) Receives the DTV video/audio signals from a set top box. Note: Only 480p, 720p and 1080i formats are supported.

∏PC AUDIO INPUT jacks

Connect these to the audio-output jacks on your PC.

”DVI (Digital Video Interface) jack Receives the digital signals from a set top box or PC etc.

’RS-232C jack

˝PC VIDEO INPUT jack

Connect to the video output port on your PC.

14

15

Downloaded from www.Manualslib.com manuals search engine