Samsung HLN5065W, HLN567W, HLN617W, HLN507W, HLN437W, HLN4365W instruction manual M S U N G

• Do not attempt to service the TV yourself. Refer all servicing to qualified service personnel. Unplug the unit from the wall outlet and refer servicing to qualified service personnel when:

- The power-supply cord or plug is damaged

- Liquid has been spilled on the unit or if objects have fallen into the unit - The TV has been exposed to rain or water

- The TV does not operate normally by following the operating instructions - The TV has been dropped or the cabinet has been damaged

- The TV exhibits a distinct degradation in performance - When the LAMP(BULB ONLY) replacement is needed

BP68-00142A-1 5/27/03 10:09 AM Page 4

Safety Instructions

pinched by objects placed on or against them. Pay particular attention to cords at plugs, convenience	FCC Information
• Protect the power cord. Power supply cords should be routed so that they won’t be walked on or
receptacles, and the point where they exit from the unit.

• Unplug the TV from the wall outlet and disconnect the antenna or cable system during a lightning storm or when left unattended and unused for long periods of time. This will prevent damage to the unit from lightning and power-line surges.

• Avoid overhead power lines. An outside antenna system should not be placed in the vicinity of over- head power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, be extremely careful to keep from touching the power lines or circuits. Contact with such lines can be fatal.

• Do not overload the wall outlet or extension cords. Overloading can result in fire or electric shock.

• Do not insert anything through the openings in the unit, where they can touch dangerous voltage points or damage parts. Never spill liquid of any kind on the TV.

• Ground outdoor antennas. If an outside antenna or cable
	EXAMPLE OF
system is connected to the TV, be sure the antenna or cable	ANTENNA GROUNDING	ANTENNA
system is grounded so as to provide some protection against		LEAD IN WIRE
voltage surges and built-up static charges. Section 810 of the	GROUND CLAMP
		ANTENNA
		DISCHARGE UNIT
National Electrical Code, ANSI/NFPA No.70-1984, pro-	ELECTRIC	(NEC SECTION 810-20)
vides information about proper grounding of the mast and	SERVICE	GROUNDING
	EQUIPMENT
		CONDUCTORS
supporting structure, grounding of the lead-in wire to an		(NEC SECTION 810-21)
antenna discharge unit, size of grounding conductors,		GROUND CLAMPS
location of antenna discharge unit, connection to grounding		POWER SERVICE GROUNDING
		ELECTRODE SYSTEM
electrodes, and requirements for the grounding electrode.	NEC — NATIONAL ELECTRICAL CODE	(NEC ART 250, PART H)

User Instructions

The Federal Communications Commission Radio Frequency Interference Statement includes the fol- lowing warning:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi- dential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guar- antee that interference will not occur in a particu- lar installation.

If this equipment does cause harmful interference to radio or television receptions, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer- ence by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a cir- cuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Warning

User must use shielded signal interface cables to maintain FCC compliance for the product. Declaration of conformity for products marked with FCC Logo. This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two condi- tions:

(1) this device may not cause harmful interference,

and

(2) this device must accept any interference

received, including interference that may cause

undesired operation.

The party responsible for product compliance:

SAMSUNG ELECTRONICS CO., LTD

America QA Lab of Samsung

85 West Tasman Drive

San Jose, CA 95134 USA

Tel) 408-544-5124

Fax) 408-544-5191

Provided with this monitor is a detachable power

supply cord with IEC320 style terminations. It may

be suitable for connection to any UL Listed person-

al computer with similar configuration. Before

making the connection, make sure the voltage rat-

ing of the computer convenience outlet is the same

as the monitor and that the ampere rating of the

computer convenience outlet is equal to or

exceeds the monitor voltage rating.

For 120 Volt applications, use only UL Listed

detachable power cord with NEMA configuration

	• If you make adjustments yourself, adjust only those controls that are covered by the operating instruc-		User Information
	tions. Adjusting other controls may result in damage and will often require extensive work by a qualified		Changes or modifications not expressly approved
	technician to restore the TV to normal.
			by the party responsible for compliance could
	• When replacement parts are required, be sure the service technician uses replacement parts specified		void the user’s authority to operate the equipment.
	by the manufacturer or those that have the same characteristics as the original part. Unauthorized		If necessary, consult your dealer or an experi-
	substitutions may result in additional damage to the unit.		enced
	• Upon completion of any service or repairs to this TV, ask the service technician to		radio/television technician for additional sugges-
			tions. You may find the booklet called How to
	perform safety checks to determine that the TV is in a safe operating condition.
			Identify and Resolve Radio/TV Interference
			Problems helpful. This booklet was prepared by
	This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:		the Federal Communications Commission. It is
	(1) This device may not cause harmful interference, and		available from the U.S. Government Printing
	(2) This device must accept any interference that may cause undesired operation.		Office, Washington, DC 20402, Stock Number
	This television receiver provides display of television closed captioning in accordance with §15.119 of		004-000-00345-4.
	the FCC rules.
4
		S A M S U N G

5-15P type (parallel blades) plug cap. For 240

Volt applications use only UL Listed Detachable

power supply cord with NEMA configuration

6015P type (tandem blades) plug cap.

IC Compliance Notice

This Class B digital apparatus meets all require- ments of the Canadian Interference-Causing Equipment Regulations of ICES-003.

Notice de Conformité IC

Cet appareil numérique de classe B respecte toutes les exigences du Règlement ICES-003 sur les équipements produisant des interférences au Canada.

5

Downloaded from www.Manualslib.com manuals search engine