13 ... English
Installation
Powering On/Off the Projector
Power

Powering On the Projector

1. Openthelenscap.
2. Ensurethatthepowercordandsignalcablearesecurely
connected.ThePowerLEDwillashamber.
3. Turn on the lamp by pressing “Power” button on the control
panel.AndthePowerLEDwillturnamber.
4. Turnonyoursource(computer,notebook,videoplayer
,etc.).Theprojectorwilldetectyoursourceautomatically.
If the screen displays "Lock" & "Source" icons, it means the pro-
jector locks on this source type and there is no such type of input
signal found.
If the screen displays “No Signal”, please make sure the signal
cables are securely connected.
If you connect multiple sources at the same time, using the
“Source” button on the remote control or control panel to switch.
Turn on the pro-
jectorrstandthen
the signal sources.
1
The lens cap must
be open then turn
on the projector.
r
If the projection lens cap is not o pened when a projector is po wered
on, users will hear a cont inuous two-beep s ound, and the inter val of
each two-beep warni ng message is about 3 second s.
r
The projector will not be t urned on and automat ically gone to a stand -
by mode if the lens cap is still c losed after two- beep sound keeps
warning for 5 times.
r
If the projection lens cap is acc identally closed while t he projector
is running, user s will hear the same b eep and the projector w ill
automatically go to a stand -by mode if the lens cap is st ill not opened
after 5 times of warn ing message.