Acu-Rite 00611A3, 411, 00609SBDIA instruction manual Troubleshooting, No outdoor sensor

Troubleshooting

		If the wireless signal indicator shows no bars:
		• Relocate the display unit and/or the outdoor sensor.
		The units must be within 165 ft (50 m) of each other.
No outdoor sensor		• Make sure both units are placed at least 3 feet (.9 m)
		away from electronics that may interfere with the
reception
		wireless communication (such as TVs, microwaves,
		computers, etc).
	no bars	• Use standard alkaline batteries (or lithium batteries in
		sensor when temperature is below -4ºF/-20ºC). Do not
		use heavy duty or rechargeable batteries. NOTE: It
		may take up to 20 minutes for display unit and sensor
		to synchronize after batteries are replaced.
		Flashing of the outdoor temperature is generally an
Outdoor		indication of wireless interference.
		1. Bring both the sensor and display unit indoors and
temperature		remove at least one battery from each.
is flashing or		2. Reinstall the battery in the outdoor sensor.
showing dashes		3. Reinstall the battery in the display unit.
		4. Let the units sit within a couple feet of each other
		for about 20 minutes to gain a strong connection.
Inaccurate		• Make sure both the display unit and sensor are
		placed out of direct sunlight and away from any heat
temperature
		sources or vents (see page 5).
Display screen		• Check that the batteries are installed correctly.
not working		Batteries may need to be replaced.

If your AcuRite product does not operate properly after trying the troubleshooting steps, visit www.AcuRite.com or call (877) 221-1252 for assistance.

7