© Adam Equipment Company 2012 Page 9 Rev C5, January 2012
show ‘250.0kg’ or ’500.0lb’ d epending on which unit you chosen, this is the
default calibration weight from the factory. Press the [UNIT] key to select the
calibration weight unit that you want to calibrate in. Press the [ON / OFF] key to
exit the calibration mode at this point or press the [Print/Hold] key to choose a
different calibration weight value (5 0kg, 100kg, 150kg, 200kg, 250kg or 100lb,
200lb, 300lb, 400lb, 500lb); Then put on the weight that you selected and press
the [TARE] key to confirm the chosen standard weight that was selected earlier.
The displayed data will flash on the d isplay and if the scale accepts the
calibration data it will calculate and store the information into the EEPROM. If an
error has occurred, the scale will display “CAL. Er” and return back to step 4 for
re-calibration. If the loaded weight is not within the range of 95% to 105% of the
weight value you selected, the scale will not calibrate but display “CAL. Er” and
return back to step 4 for re-calibration. )
6. Check the calibration by putting the weight that you calibrated at back on the
scale, if it is off repeat the calibration process again.