3.4. Inserting the Paper Roll
•Switch the printer on by sliding the
I/O (ON/OFF) switch to the left.
• Lift the top cover by squeezing the sides with your fingers and pulling up.
•Insert the ”under” end of paper roll into the slot of the internal compartment.
• Push the paper as deep as possible into the slot.
• Press the PAPER FEED button until paper appears at the Paper Cutter.
•Put paper roll into the compartment and close the lid.
Paper roll
There is only 1 kind of paper roll used in this unit. ADC® sells extra paper rolls, contact our Customer Service Department for more details.
Note:
•The paper roll is 1" thick
•If there are problems when inserting the paper, cut the edge so that the corners of the paper are square (90°, see below).
✔
4. CARRYING OUT A PRINTING OPERATION
4.1. Power On
Before powering the printer, check that the batteries are inserted properly.
•Push the O/I ON/OFF switch to the left side in order to power the printer.
•The green LED will light.
4.2. Paper Feeding
Before you start the printing operation, check that the paper is installed properly in the correct position.
If it is not, press the PAPER FEED button to feed additional paper into the printer.
Note:
•Press the button once to advance 1 line.
•Continually depressing the button will advance multiple lines.
4.3. Printing
•Connect the printer with the monitor as explained in Section 3.3.
•Push the print button on the monitor (for details, refer to the manual of the related monitor).
4.4. Low Voltage Indication
When the LED is flashing under
•When the batteries are replaced the printer will
operate properly.
Note:
•If the printer is connected with an AC adapter, the low voltage indicator will not occur.
4.5. Power Off
After you are done printing, push the O/I (ON/OFF) switch to the right side in order to turn off the printer.
•The LED will become dark.
5 | 6 |
