ADCP-80-524 • Issue 1 • November 2001

7.2Cleaning

If excessive dirt is found during the inspection, brush or wipe dust and dirt from the fuse panel with a soft bristle brush or soft cloth. Care should be taken not to damage the fuses or any wiring.

7.3Adjustments

No adjustments in the field are indicated or required. If a circuit is not operating properly, contact ADC Customer Assistance (see Section 8, Customer Information and Assistance).

7.4LED Replacement

The power-on and fuse alarm LEDs may be replaced as follows:

1.Pull LED out slowly from the front of the fuse panel.

2.Disconnect both tabs on the LED from the mating terminals (quick-connects or fastons) on the wires.

3.On the replacement LED, connect the tin tab to the mating terminal on the red wire, and connect the brass tab to the mating terminal on the black wire.

4.Push the LED back into the panel.

Page 31

© 2001, ADC Telecommunications, Inc.