Installation | |
|
|
Termination blocks
Side view of
termination block*
Terminator PCB
Terminator resistor Chassis backplane
RTN B]
RTN A
FGND
Craft
JP7
- B
JP12
B+
- A
A+
*Install the 100Ω termination block with the resistor facing towards the backplane.
Figure 5. Installing Line Terminators
3Install the BITS terminating blocks (catalog number
4Connect Bits A and Bits B posts to your Synchronous Optical Network (SONET) clock synchronization source (SONET minimum clock or better). Use a frame ground post as a shield, if needed.
Connect Test Access
5Connect the Test Access TTIP, TRING, RTIP, RING, and Frame GND posts to the external test head.
ThinMux Chassis | January 3, 2002 | 9 |