ADC AD-360X2 B. ADJUSTMENTS

AS REQUIRED:

In cleaning and care of the cabinet, avoid using harsh abrasives. A product intended for the cleaning of appliances

is recommended.

B. ADJUSTMENTS

SUGGESTED INTERVAL

6 MONTHS

Drive belts should be examined. Cracked or seriously frayed belts should be replaced. Tighten loose drive

belts when necessary, and check belt alignment. Complete operational check of control and valves. Complete

operational check of ALL safety devices (door switches, sail switch and burner high limits and lint chamber

thermostats).

12 MONTHS

Inspect bolts, nuts, screws, and nonpermanent gas connections, (unions, sail switch, burner, and lint chamber

thermostats).

Contents

Main Retain This Manual In A Safe Place For Future Reference Important AD-360X2 Page Page Table of Contents Page SECTION I IMPORTANT INFORMATION A. SAFETY PRECAUTIONS SECTION II ROUTINE MAINTENANCE A. CLEANING B. ADJUSTMENTS SECTION III INSTALLATION REQUIREMENTS A. ENCLOSURE, AIR SUPPLY, AND EXHAUST REQUIREMENTS B. ELECTRICAL AND GAS REQUIREMENTS NOTE: Any burner changes must be made by a qualified technician. C. OPERATIONAL SERVICE CHECK PROCEDURE SECTION IV DESCRIPTION OF PARTS A. CONTROL PANEL B. CONTROL AND RELAY PANELS C. COIN BOX D. DOOR SWITCH (HINGE BLOCK) G. BASKET (TUMBLER) AND DRIVE MOTOR ASSEMBLY ARRANGEMENT F. BASKET (TUMBLER) E. MICROPROCESSOR ASSEMBLY Page K. GAS BURNER M. HI-LIMIT THERMOSTAT L. SAIL SWITCH Page Page SECTION V SERVICE A. INTRODUCTION B. CONTROLS (COMPUTER) Page IMPORTANT: Pipe dope must be applied to manifold before installing it into new valve. Page C. BURNER CONTROLS (GAS) NOTE: Manometers are available from the factory by ordering part number 122804. Page NOTE:Take note of where wires are for installing the new module. D. THERMOSTATS AND TEMPERATURE SENSOR IMPORTANT: UNDER NO CIRCUMSTANCES should the heat circuit safety devices ever be disabled. Page E. SAIL SWITCH ASSEMBLY IMPORTANT: UNDER NO CIRCUMSTANCES should heat circuit safety devices ever be disabled. NOTE: Be careful not to drop or lose the twin speed nut on the backside of the sail switch. F. FRONT PANEL AND MAIN DOOR ASSEMBLIES IMPORTANT: UNDER NO CIRCUMSTANCES should the door switch be disabled. NOTE: Be careful not to lose the plastic washer on the hinge pin. Page Page Page SECTION VI BCD-1 TYPE MODULE A. INTRODUCTION B. GENERAL SYSTEM INFORMATION Page Page C. G-760 DIRECT SPARK IGNITION (DSI) FLOWCHART D. TROUBLESHOOTING Page NOTE: Preliminary steps - DO NOT OMIT - to minimize the time required to troubleshoot this system. Page 37 d. Troubleshooting Flowchart - Quick Reference... First Visual Check NO SPARK AND SYSTEM DOES NOT WORK 38 e. Troubleshooting Flowchart - Quick Reference... Second Visual Check SPARK PRESENT BUT MAIN BURNER DOES NOT COME ON 39 f. Troubleshooting Flowchart - Quick Reference... Third Visual Check MAIN BURNER LIGHTS BUT DOES NOT STAY ON Page NOTE: During the purge period, check to be sure that ALL gas shutoff valves are open. restart the dryer. IMPORTANT: The gap setting on the ignitor/flame-probe assembly is critical. Page Page Page Page Page SECTION VII TROUBLESHOOTING A. PHASE 5 COIN SYSTEM DIAGNOSIS Page Page Page Page C. NO START CONDITION D. NO DISPLAY CONDITION E. dSFL DISPLAY CONDITION F. dOOr DISPLAY CONDITION SECTION VIII DATA LABEL INFORMATION A. DATA LABEL B. USING A MANOMETER NOTE: Place manometer in a position so that readings can be taken at eye level. C. LIGHT EMITTING DIODE (L.E.D.) DISPLAY CODES