ADC Campus RS Destop Unit COMPLETE SYSTEM INSTALLATION

Installing and Configuring the Line Unit

Campus-RS Line Unit

	CM
	U-7
	10	M
		AN
		AG
		EM
		EN
P		T U	NIT
	OW
	ER		SL
			OT

AL
AR
MAJ	MS
	OR
MI
NO	R
ACO

Ca
mp
L	us		HR
INE		U		A
			NIT
HD	SL
TE
ST
PO
RT
C	R	S-2
	ON		32
			SO
			LE

Ca
mp
L	us		HR
INE		U		A
			NIT
HD	SL
TE
ST
PO
RT
C	R	S-2
	ON		32
			SO
			LE

Ca
mp
LI	us		HR
NE		U		A
			NIT
HD	SL
TE
ST
PO
RT
C	R	S-2
	ON		32
			SO
			LE

RESET

Ca
mp
L	us		HR
INE		U		A
			NIT
HD	SL
TE
ST
PO
RT
C	R	S-2
	ON		32
			SO
			LE

Campus-Star chassis

3Slide the Line Unit into the slot on the front of the Campus-Star chassis that corresponds to the slot into which you installed the interface card. Use the guide rails to align the card.

4When the Line Unit is in as far as possible, push the retaining latch in until it snaps into place. Assuming the Campus-Star power is on, the Line Unit performs a power-on test. After completing the test, the HDSL LED flashes red.

COMPLETE SYSTEM INSTALLATION

To complete the installation of the Campus-RS system and ready it for use:

1Install the remote unit. This may be an interface card installed in a Campus Desktop Unit or an interface card and line unit installed in another Campus-Star chassis.

2Connect the cables according to the instructions in the Campus-Star or Campus-RS Desktop Unit documentation.

Campus-RS Line Unit User Manual May 29, 2002 11