Installing and Configuring the Line Unit

SET THE HDSL OPERATING MODE AND TRANSMISSION RATE

This section provides generic instruction for setting the HDSL Operating Mode and transmission rate. The actual steps depend on the interface card mated with the Line Unit. Refer to the manual for the interface card for a description of configuration options and complete configuration instructions.

LCD display

Slot selection control pad

 

System alarm LEDs

CMU-710 MANAGEMENT UNIT

SLOT

ALARMS

 

 

MAJOR

 

 

 

 

 

 

 

 

 

 

MINOR

 

 

 

 

 

ACO

 

NEXT

ENTER

ESC

RS-232

 

 

POWER

 

 

 

RESET

 

 

Menu buttons

 

Console port

Reset button

 

 

 

The steps in this section use the menu buttons and LCD on the Campus-Star’s Campus Management Unit (CMU). To set the HDSL Transmission Rate:

1Use the Slot selection buttons to select the slot in which you installed the Line Unit. The LCD displays:

MARGIN (LOC/RMT) 1:XX/XX 2:XX/XX

2Press Escape four times to go to the top level menu.

3Press Next until HDSL LINK CONFIG & STATUS displays, then press Enter.

4Continue with one of the following sections, depending on whether you are using Standard Mode or Extended Mode.

Campus-RS Line Unit User Manual

May 29, 2002

13