Adcom GTP-830 Input Settings Audio=Video Video=Video, Mode=Stereo Dynamic Range=N/A

INITIAL SETUP

surround
rear left		Note: If space permits, install surrounds
	2-3 ft.	2-3 feet above viewers.This helps
		to minimize localization effects.

3.6 Input Settings

Input Settings shows information about the current state of operation of the GTP-830, and repeats much of the same information shown on the GTP- 830’s front panel. This menu should be the only part of the on-screen display you might elect to use reg- ularly after setup is complete, as it allows you to easily see the operating mode from the listening position.

Highlight INPUT SETTINGS in the SETUP menu and press Select on the remote. You will see a screen similar to the following :

INPUT SETTINGS

AUDIO=VIDEO 1

VIDEO=VIDEO 1

MODE=STEREO

DYNAMIC RANGE=N/A

The available choices in each of the fields can be selected with the Left or Right arrow buttons on the remote; confirm the choice with Select button.

AUDIO = identifies the selected audio input

VIDEO = identifies the selected video input

MODE = indicates the surround mode of the select- ed input (DOLBY DIGITAL, DTS, PRO LOGIC, HALL, STEREO).

DYNAMIC RANGE = indicates the dynamic range currently selected (100%, 75%, 50% and 25%) in Dolby Digital mode only, or N/A for the other modes.

Highlight SAVE & EXIT and press Select to save the altered settings and return to the SETUP menu. Otherwise, select DO NOT SAVE & EXIT to leave without saving any changes.

DO NOT SAVE AND EXIT SAVE AND EXIT

ADCOM OWNER’S MANUAL 35