Adder Technology AV Series manual To connect the link cables, AdderLink AV100 & AV200 models

To connect the link cable(s)

The links between the transmitter and receiver modules are made using between one and four twisted pair cables, specified to Category 5 or higher. Each cable carries video and audio signals to each receiver module.

When a single receiver is attached to a link cable, the maximum length of that link cable is 300m (1000 feet).

STANDARD LINK

TRANSMITTER RECEIVER

Overall maximum link length: 300m

However, if further receivers are connected in cascade to the initial receiver using its LINK OUT port (AdderLink AV101 models only), then the overall length of the link cables used must be reduced. For further information, please refer to the section Making cascade connections.

NOTE: Where possible, avoid laying the twisted pair link cable(s) alongside power cables.

AdderLink AV100 & AV200 models

1 Attach the connector of the link cable to the socket labelled LINK on the AdderLink AV100/AV200 transmitter. There

should be a click when the cable is fully inserted	TRANSMITTER
and locked in place.		10

AdderLink AV104 models

1Attach the connector of the first link cable to the socket

labelled L1 OUT on the AdderLink AV104 transmitter.

There should be a click when the cable is fully TRANSMITTER inserted and locked in place.

10

  

Note: AV200 transmitters and 0

receivers must not be connected, via a CATx link, to AV100, AV101 or AV104 modules. Cascade connections to

other transmitter types are possible, however, using the video and audio out ports. For further information, please

refer to the section Making cascade connections.

2Attach the connectors of the remaining link cables to the sockets labelled L2 OUT to L4 OUT, as required.

In all cases, there should be a click when the cable is fully inserted and locked in place.

LINK 4 LINK 3 LINK 2

4

 

11