Mouse button switching modes
You can use a three button mouse to switch between systems. However, when used in this way, the action of the middle mouse button or scroll wheel click is ‘trapped’ by the Adder TS4 and is not passed to the system. This makes it unavailable for use in controlling applications on the selected system. The scroll wheel scrolling action is unaffected and passed on normally to the systems, only the scroll wheel click is used by the Adder TS4.
•To use the mouse buttons to change systems, use options U1 (default) or U4.
•To use the scroll wheel click/third mouse button with the systems, use options U3 or U5.
•To report only a simple
To change the mouse button switching modes
1Enter configuration mode: Press and hold the SELECT button until the SYSTEM readout shows c.
2Press 
followed by a number to select the required mouse button setting, as follows:
System channels are switchable using a
System channels are not switchable using the mouse. Adder TS4 reports
System channels are not switchable using the mouse. Adder TS4 reports
System channels are switchable using a
System channels are not switchable using the mouse. Adder TS4 reports IntelliMouse mode to the systems.
3When the mouse button selection has been made, press 
to fix it and
then press 
to exit from configuration mode.
All channel/active channel cycling
The Adder TS4 provides the option, when cycling between the system channels, to visit each channel (irrespective of whether an active system is connected)
or to only select active channels. You can affect the keyboard/mouse setting independently from the front panel SELECT switch setting.
To change keyboard/mouse channel cycling
1Enter configuration mode: Press and hold the SELECT button until the SYSTEM readout shows c.
2Press 
followed by a number to select the required keyboard/mouse channel cycling setting, as follows:
Cycle between all ports when switching with ‘hotkeys and Tab’ or three button mouse (default).
Cycle between active ports only when switching with ‘hotkeys and Tab’ or three button mouse (default).
3When the channel cycling selection has been made, press 
to fix it and
then press 
to exit from configuration mode.
To change SELECT button channel cycling
1Remove power from the Adder TS4. If any systems are active, either switch them off or remove their keyboard link connectors from the Adder TS4. If an optional power supply is used, remove it.
2On the rear panel, click mini switch 6 to the required position, as follows:
•To cycle between all system ports, set switch 6 to OFF.
•To cycle between active ports only, set switch 6 to ON.
3
Resetting and restoring default settings
On occasions it may be necessary to reset the Adder TS4 or to remove all custom settings and return the Adder TS4 to its factory default state.
To reset the Adder TS4
1On the rear panel, click mini switch 8 to its ON position for a moment and then return it to its OFF position.
To restore default settings
1Enter configuration mode: Press and hold the SELECT button until the SYSTEM readout shows c.
2On the connected keyboard, press 
and then press 
, followed by 
to perform the restoration of the default settings. The SYSTEM readout will momentarily show 
to confirm that the process is complete.
13
