StorNext 3.0 Upgrade Guide
Document 6-01620-04 Rev A
March 2007
Introduction 3
Introduction 0
This document provides information about upgrading to StorNext 3.0 from a
previous version. Instructions are provided for metadata controllers (MDCs)
running both StorNext File System (SNFS) and StorNext Storage Manager
(SNSM), as well as for MDCs running SNFS only.
For upgrade procedures, or to learn how to contact Quantum for assistance, see
the following sections:
•Getting Ready to Upgrade on page 3
•Running the Pre-Installation Script on page 5
•Upgrading to StorNext 3.0 (SNFS and SNSM) on page 7
•Upgrading to StorNext 3.0 (SNFS Only) on page 8
•Contacting Quantum on page 16
Getting Ready to Upgrade 0
This section includes important information about upgrading to StorNext 3.0.
Review the following sections before upgrading:
•Upgrade Guidelines
•Converting a Metadata Controller Running IRIX
•Upgrading HA Systems
•Upgrading the Client Software
Upgrade Guidelines 0
Before upgrading StorNext, review the following upgrade guidelines:
• The trashcan feature has been removed in StorNext 3.0. Before upgrading to
StorNext 3.0, you must empty the trashcan on all file systems where this
feature is enabled. If the trashcan directories are not removed, the upgrade
will fail.
To empty the trashcan on a file system where it is enabled, change to the file
system directory (for example /stornext/snfs1). Then, at the command
prompt, type:
rm -rf TrashCan
Repeat this procedure for all file systems.
• Before upgrading, make sure there is no I/O activity. On the StorNext home
page, the number of store candidates should be 0. For tape drives, make sure
no media is mounted and no read/write operations are being performed. If
there is I/O activity, wait for the I/O activity to complete before upgrading. If
you attempt to perform an upgrade during a period of high activity, the
upgrade may fail.