Installation instructions

5.Install the L brackets on the outer sill with the short side of the bracket against the back of the

inner sill. Install one L bracket 7.5 to each side of the center line. See Fig. 5.

6. Carefully lift the air conditioner and slide it into

the open window. Make sure the bottom guide of

the air conditioner drops into the notches of the L

brackets. When the air conditioner drops into the L

brackets, the air conditioner will be centered in the

window opening as show in Fig. 6.

While steadying the air conditioner, carefully bring

the window sash down behind the top channel

of the air conditioner, as shown in Fig. 7.

First, fix both sides onto the window sill with two 3/4

screws and one 2/5 screw ( which is unscrewed from

each side of the unit). Then fix top channel to window

sash with one 3/4 screw and fix side curtain frames

with four 3/4 screws as shown in Fig.6.

Outer Sill

Inner Sill

 

 

 

3/4''

Screw

Center Line

 

 

3/4''

Screw

 

7.

 

Bracket

5

 

7.

 

Short Side

5

 

 

 

Fig. 5

 

 

 

 

 

 

Foam

 

3/4

screw

 

 

 

 

3/4

screw

3/4 screw

 

 

3/4

screw

 

 

2/5

screw

 

 

 

 

 

 

 

 

3/4

screw

3/4

screw

 

 

 

3/4

screw

 

7. If storm window presents interference, fasten a

2'' wide wood strip to the inner window sill across

the full width of the sill. The wood strip should be thick enough to raise the height of the window sill so that the unit can be installed without interference from the storm window frame, as show in Fig. 8.

Top of wood strip should be approximately 3/4'' higher than the storm window frame to help condensation to drain properly to the outside..

Fig. 6

Seal

L Bracket

About 5

Install a second wood strip (approximately 6'' long by

11/2''wide and same thickness as first strip) in the center of the outer sill flush against the back of the inner sill. Screw the L brackets into this strip.

This will raise the L bracket as shown in Fig. 8.

Fig.7

3/4''Clearance

Storm window

frame

Inner sill

Fig.8

8

Page 9
Image 9
Admiral AAW-05CR1FHUE, AAW-06CM1FHUE, AAW-05CM1FHUE, AAW-06CR1FHUE manual If storm window presents interference, fasten a

AAW-06CR1FHUE, AAW-05CR1FHUE, AAW-05CM1FHUE, AAW-06CM1FHUE specifications

Admiral AAW-06CR1FHUE, AAW-05CM1FHUE, AAW-06CM1FHUE, and AAW-05CR1FHUE represent advanced models in the realm of air defense systems, renowned for their cutting-edge features, technologies, and specifications. These systems are engineered to provide robust protection against aerial threats, blending innovation and effectiveness.

Starting with the AAW-06CR1FHUE, this model is distinguished by its dual-layered defense mechanism that integrates both long-range interception technologies and close-in systems. Its radar systems utilize phased-array technology, enabling rapid detection and tracking of multiple targets simultaneously. This model is equipped with state-of-the-art missile systems that boast high maneuverability and precision targeting capabilities, making it adept at countering diverse threats, from drones to ballistic missiles.

Meanwhile, the AAW-05CM1FHUE offers a variant focused on countering medium-altitude aerial threats. It incorporates an advanced sensor suite that enhances situational awareness, allowing for seamless integration with existing command and control frameworks. The AAW-05CM1FHUE's missile systems are optimized for speed and agility, featuring advanced propulsion technologies that enhance their range and response times.

The AAW-06CM1FHUE emphasizes adaptability, featuring modular system architecture that allows for rapid upgrades and customization based on operational requirements. This characteristic makes it suitable for various theaters, ensuring that military units have the flexibility to respond to evolving air threats. Its software-driven capabilities enhance decision-making processes, utilizing artificial intelligence to analyze and triage incoming threats effectively.

Lastly, the AAW-05CR1FHUE stands out for its cost-effectiveness and efficiency. It employs advanced targeting algorithms and an integrated communication architecture that reduces latency in threat response time. This model is particularly valued for its ability to operate in contested environments, employing electronic countermeasures to enhance survivability and diminish the effectiveness of enemy targeting systems.

Collectively, these models reflect a significant leap in air defense technology, integrating aspects such as AI, modularity, and advanced propulsion systems. Their sophisticated radar and sensor configurations, coupled with their precise interception capabilities, make the Admiral AAW series indispensable in modern military operations, ensuring a strategic edge in securing airspace against diverse aerial threats. As air defense needs continue to evolve, these systems represent a forward-thinking approach to national security and defense preparedness.