ADT Security Services 9600 3.2 User Programming

8VHU3URJUDPPLQJ 3URJUDPPLQJ

8QLPRGH31& 

3.2 User Programming

The Unimode 9600 is completely field programmable and requires no special software

skills. While programming the Unimode 9600, the fire protection capabilities of the

control panel are enabled.

Site-specific programming may be accomplished in three ways:

•Autoprogramming Feature - This is a convenient method for quickly bringing the

FACP addressable SLC devices on-line without the necessity of programming each

device individually. Refer to "Autoprogram" on page 87 for a detailed description

of Autoprogramming

• Manual programming or editing, using the FACP keypad or a PC keyboard

• Off-line Programming and Editing Feature - allows creation and editing of site-

specific custom programs using a Windows-based computer. For programs

requiring a large amount of data entry, this method may be preferred. A PK-9600

programming kit can be ordered for this purpose

The System All Normal screen will be displayed in a programmed system with no active

alarms, troubles or supervisories, as illustrated below:

Programming and Read Status mode can be entered while the panel is in any mode of

operation. If the panel is in alarm, the alarm condition must be acknowledged before

entering other modes. To access any of the programming or read status features, the Enter

or Mode key must be pressed, which will cause the LCD to display the following:

Pressing 1, while this screen is being displayed, will cause the control panel to enter the

Read Status feature which allows the user to view the programmed features and status of

the control panel The Read Status feature is not password protected. Refer to "Read

Status" on page 117 for a detailed description of this feature.

Pressing 2 will select user Programming which may only be accomplished by an

authorized person. After pressing 2, a screen will prompt for a password. After entering

the correct password, the user may select from a list of programming options.

Exit Programming or Read Status

The programmer can exit Read Status or Programming mode by repeatedly pressing the

keypad ESC (Escape) key until the display reads System All Normal. Note that the data

which is entered during Programming mode is not saved until the programmer exits this

mode by repeatedly pressing the ‘ESC’ key. If the Reset key is pressed or power is lost

before exiting Programming mode, all data which was just entered will be lost.

See Page

