SYSTEM TROUBLE ERROR CODES
Your ADT Safewatch EZ System is constantly monitoring its own components, as well as all critical services, such as AC power and the telephone line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble occurs, the EZ Touchpad will caution you with a Trouble TBL light and a beeping sounder.
If you cannot immediately fix the trouble, the system can still be used. Simply press SILENCE to view the trouble as described below and press SILENCE again to exit the VIEW TROUBLE mode. The system can now be armed.
To view the trouble, press SILENCE, count the number of Trouble TBL and READY flashes and refer to the following table. If there is more than one trouble to view, press SILENCE again to scroll to the next trouble, and again to exit the VIEW TROUBLE mode. The Trouble TBL light will remain pulsing as a reminder if the trouble is still present. NOTE: If EZ Touchpad siren chirps once every 10 sec- onds, call for service.
TBL Flashes / | READY | Trouble Condition | Action | |
Touchpad beeps | Flashes | |||
|
| |||
STEADY | NONE | Zones Bypassed | This is a reminder that zones have been bypassed (by pressing BYPASS). If it is | |
|
|
| necessary to bypass any inoperative zones, it is important to have the zones re- | |
|
|
| paired as soon as possible. | |
|
|
|
| |
1 | NONE | AC Power Failure | This trouble will occur if AC power is not present. Make sure the system trans- | |
|
|
| former is plugged into its AC receptacle and check the circuit breaker, otherwise | |
|
|
| call for service. | |
|
|
|
| |
2 | NONE | Low Battery | If there has been a recent power failure, the battery may be partially depleted and | |
|
|
| must be recharged by the control panel. If the trouble does not clear in 24 hours, | |
|
|
| call for service. | |
3 | NONE | Communication | The system was not able to report to central station. If this is due to a temporary | |
|
| Failure | interruption in the telephone service, the trouble can be cleared when the service | |
|
|
| is restored by pressing SILENCE again. | |
|
|
|
| |
4 | NONE | Telephone Line Cut | The telephone line has failed. If telephone service has been temporarily inter- | |
|
|
| rupted, the trouble will clear when restored. Otherwise, call for service. | |
|
|
|
| |
5 | NONE | Bell/Siren Trouble | There is a problem with the Bell or Siren. Call for service. | |
|
|
|
|
17
