Chapter 3. Operation
TX (DB) | Sets the Tx direction transmit level points. The transmission level is indicat- |
| ed in dBm. Range is from 0 to 9.9 dBm. Default is 6.0. |
RX (DB) | Sets the Rx direction transmit level points. The transmission level is indicat- |
| ed in dBm. Range is from 0 to 9.9 dBm. Default is 3.0. |
SVC MODE | Indicates whether the module is IN SERVICE or OUT OF SVC. This does not in- |
| dicate whether the port has been mapped. For proper operation, the port |
| must be mapped using the DS0 MAPS menu. |
LINE Z | Sets the line impedance. Choices are 600 OHMS, 900 OHMS, 600 OHMS + |
| 2.16∝ F, 900 OHMS + 2.16 ∝ F, and AUTO. |
TANDEM | Displays additional Tandem information about the module when it is used |
| in Tandem (E&M) mode. (To access submenus for this item, use the arrow |
| keys to scroll to the TANDEM column for the module you want to edit, and |
| then press Enter.) |
CONVERSION | Sets the port to either loop start or ground start mode. |
MODE |
|
SUPERVISION | Sets the supervision method used to either IMMEDIATE or WINK. |
DIAL TONE | Used to enable or disable the |
RING BACK | Used to enable or disable the option of generating ring back tone towards |
TONE | the |
ANSWER | Causes the polarity of tip and ring to be reversed when the |
SUPERVISION | Can be enabled or disable. |
DNIS OPTIONS | Enable/disable. |
DNIS DELAY | Sets the amount of time the FXS will wait after sending a wink before send- |
| ing answer supervision toward the CO. |
Quad FXS Voice Module User Manual | 61175408L1 |
