NT1 ACE User Manual
If the ERROR indicator is not illuminated and the READY indicator is flashing, a network test is in progress. Network command tests cause a faster 8 Hz flash rate. Terminal equipment commanded tests produce a slower 1 Hz flash rate.
Passive Bus Description
The Local Bus interface may be used to connect up to eight TEs to the NT1 ACE. This arrangement is referred to as a Passive Bus. See the section Short Passive Bus Configuration on page 9 for detailed information.
Inspection
After unpacking the unit, immediately inspect it for possi- ble shipping damage. If damage is discovered, file a claim immediately with the carrier; then contact ADTRAN Cus- tomer Service. If possible, keep the original shipping con- tainer for use in shipping the NT1 ACE for repair or for verification of damage during shipment.
•Never install telephone wiring during a lightning storm.
•Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
• Never touch uninsulated telephone wires or termi- nals unless the telephone line has been disconnect- ed at the network interface.
•Use caution when installing or modifying tele- phone lines.
| NT1 ACE User Manual | 3 |
