NT1 ACE User Manual
powered from the NT1, verify that the total power require- ment of the connected TE is less than 8.9 watts.
To connect the NT1 ACE to the NT1 Power Supply, perform the following steps as illustrated in Figure 4.
1.Connect the Power Supply to the NT1 ACE at the POWER jack located on the NT1 ACE.
2.Plug the Power Supply into the nearest wall outlet supplying 110 VAC, 60 HZ.
3.On the NT1 ACE, verify that the POWER and ERROR indicators are illuminated. After approximately 15 seconds, the READY indicator should flash at a 1 Hz rate. Should any of the indicators fail to operate as stated, see the section Troubleshooting on page 11.
POWERNETWORK LOCAL
1 0 0 - 1 2 0
VA C
ADTRAN
ISDN PS2
READY | ERROR | POWER |
Figure 4. Power Supply Connection
| NT1 ACE User Manual | 7 |
