®
Quick Start Guide
| For more detailed documentation, visit us online at www.adtran.com. | |||||
NetVanta 2300/2400 |
|
| P/N 1202366L2, 1202367L2 | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NetVanta 2300/2400 Rear Panel Layout
Depending on your configuration, you may need to set a default gateway as well using the (config)#ip default gateway command. If IP routing is enabled on the unit, do NOT set a default gateway.
ENABLE TELNET ACCESS
The following steps create a password of adtran for Telnet access. By default, Telnet access is enabled with a password of password.
1.Verify that the prompt of your unit displays (config)#.
2.Enter line telnet 0 4 to change the configuration parameters for the Telnet sessions.
3.Enter login to initiate Telnet access.
4.Enter password adtran to change the login password for the Telnet sessions.
5.Enter exit to return to the Global Configuration mode.
6.Verify that the prompt of your unit displays (config)#.
7.Enter do write memory to save the current configuration.
CONFIGURE YOUR APPLICATION
More detailed documentation for configuring your ADTRAN unit is provided on the ADTRAN OS System Documentation CD included in your shipment. For more detail on hardware setup, refer to the Hardware Installation Guide. For more detail on configuring your system, refer to the ADTRAN Operating System (AOS) Command Reference Guide, configuration guides, and technical support notes.
Important: For additional details on product features, specifications, installation, and safety, refer to the appropriate Hardware Installation Guide on the ADTRAN OS System Documentation CD shipped with the base unit and available online at www.adtran.com.
CONSOLE PINOUTS
Pin | Name | Description |
|
|
|
1 | DCD | Data Carrier Detect (output) |
2 | RD | Receive Data (output) |
3 | TD | Transmit Data (input) |
4 | DTR | Data Terminal Ready (input) |
5 | SG | Signal Ground |
6 | DSR | Data Set Ready (output) |
7 | — | Unused |
8 | CTS | Clear to Send (output) |
9 | — | Unused |
ETHERNET PINOUTS
Pin | Name | Description |
|
|
|
1 | TX1 | Transmit Positive |
2 | TX2 | Transmit Negative |
3 | RX1 | Receive Positive |
4, 5 | — | Unused |
6 | RX2 | Receive Negative |
7, 8 | — | Unused |
Quick Start Guide, | Technical Support | Copyright © 2005 ADTRAN, All Rights Reserved |
