ADTRAN NetVanta Series manual Create a T1 to a Virtual Interface Cross-Connect, Alternately

Create a T1 to a Virtual Interface Cross-Connect

For this example we will configure a T1 WAN interface with DS0s 1 through 10 for data. The following steps assume the Global Configuration mode is currently active. Verify that the prompt of your unit displays (config)#.

1.Enter interface t1 1/1 to activate the interface configuration mode for the T1 WAN interface.

2.Enter tdm-group 1 timeslots 1-10to create a TDM group for DS0s 1-10 on the T1 network connection (t1 1/1).

3.Enter no shutdown to activate the interface to pass data.

4.Enter exit to return to the Global Configuration mode.

5.Enter cross-connect 1 t1 1/1 1 frame-relay 1 to connect DS0s 1-10 of the T1 network connection (t1 1/1) to the virtual frame-relay interface fr 1.

Alternately,

6.Enter cross-connect 1 t1 1/1 1 ppp 1 to connect DS0s 1-10 of the T1 network connection (t1 1/1) to the PPP interface labeled 1.

Configure the Multilink PPP interface

The following steps assume the Global Configuration mode is currently active. Verify the prompt of the unit displays (config)#.

1.Enter interface ppp 2 to access the configuration parameters for the PPP interface.

2.Enter ip address 192.22.73.1 255.255.255.0 to assign an IP address to the PPP interface using a 24-bit mask.

3.Enter ppp multilink to configure the PPP interface for multilink PPP.

4.Enter no shutdown to activate the interface to pass data.

5.Enter exit to return to the Global Configuration mode.

61200890L1-42B Technical Support 1-888-4ADTRAN (1-888-423-8726) 5