Advantech MIC-3043 user manual Before Operating the System, Installing a 3.5 Hard Disk Drive

To remove a card:

1.Unscrew the screws on the card front panel. Release the locking latches on the handles.

2.Lift the upper handle up and press the lower handle down to release the card from the backplane.

3.Slide the card out.

2.3.2 Before Operating the System

Before operating your system, first check your power supply source. Adjust the switch on the power supply to the correct voltage.

Two mounting flanges are included for users who would like to install the MIC-3043 on a 19" rack.

2.3.3 Installing a 3.5" Hard Disk Drive

Follow these procedures to install 3.5" hard disk drives in the MIC-3043:

1.Open the disk tray door and remove the mobile rack. For a SCSI version, the SCSI ID is shown on the mobile rack panel. This is the same ID that the SCSI control would find after system startup.

2.Mount the HDD (SCSI/IDE/SATA) on the mobile rack with screws.

3.Slide the HDD with mobile rack back into the tray.

4.Power on the system and check that the HDD can be found at the SCSI initialization.

Note: (1) The SCSI version (MIC-3043C) must be used with a RIO module that has a SCSI con- troller, like RIO-3309S-A.

(2)The SCSI ID is assigned by the internal SCSI adaptor of MIC-3043, #0 and #1 are fixed and cannot be changed. Users can read the number on the disk mobile rack..

11 Chapter2