2.3.4 Connecting the rear I/O module
The
1.Remove the blank panel above the system RIO slot. (We suggest removing all the blank panels before inserting the RIO module.
2.Users will find two cables inside, one IDE
3.Connect each cable to its connector on the I/O board, and then slide the RIO module into the card cage.
4.Power up the system and check that all the storage devices work properly.
2.3.5Configuring the
The
Note: (1) Not all RIO modules support SCSI feature with RAID function.
(2)
Figure 2.4: SCSI adaptor
12 |