2.6 Clear CMOS (S2)

Warning! To avoid damaging the computer, always turn off the power supply before setting “Clear CMOS.” Before turning on the power supply, set the jumper back to “3.0 V Battery On.”

This jumper is used to erase CMOS data and reset system BIOS informa- tion.

The procedure for clearing CMOS is:

1.Turn off the system.

2.Short pin 2 and pin 3.

3.Return jumper to pins 1 and 2.

4.Turn on the system. The BIOS is now reset to its default setting

Table 2.3: CMOS clear (S2)

Condition

Result

 

 

unpressed*

Normal

 

 

pushed

Clear CMOS

 

 

* default setting

 

2.7 Installing DIMMs

The procedure for installing DIMMs is described below. Please follow these steps carefully. The number of pins are different on either side of the breaks, so the module can only fit in one way. DIMM modules have different pin contacts on each side, and therefore have a higher pin den- sity.

1.Make sure that the two handles of the DIMM socket are in the “open” position. i.e. The handles remain leaning outward.

2.Slowly slide the DIMM module along the plastic guides on both ends of the socket.

13

Page 23
Image 23
Advantech PCM-9372 user manual Clear Cmos S2, Installing DIMMs, Cmos clear S2