3.Press the DIMM module right down into the socket, until you hear a click. This is when the two handles have automatically locked the memory module into the correct position of the socket.
To remove the memory module, just push both handles outward, and the module will be ejected from the socket.
2.8 IDE, CDROM hard drive connector (CN13)
The
2.8.1 Connecting the hard drive
Connecting drives is done in a
1.Connect one end of the cable to CN13. Make sure that the red (or blue) wire corresponds to pin 1 on the connector, which is labeled on the board (on the right side).
2.Plug the other end of the cable into the Enhanced IDE hard drive, with pin 1 on the cable corresponding to pin 1 on the hard drive.
(See your hard drive’s documentation for the location of the con- nector.)
If desired, connect a second drive as described above.
Unlike floppy drives, IDE hard drives can connect to either end of the cable. If you install two drives, you will need to set one as the master and one as the slave by using jumpers on the drives. If you install only one drive, set it as the master.
2.9 Solid State Disk
The
2.9.1 CompactFlash (CN21)
The CompactFlash card shares a secondary IDE channel which can be enabled/disabled via the BIOS settings.
| 14 |
